Mesh rebuild scan

The request

Attached is a rough phone scan (STL) of a small block with one hole through it. Rebuild the clean part this is a scan of, as one sub-part named `block`, standing where the scan stands (Z up, same origin, resting on the same plane), with controls `length` (±10 mm) and `boreDiameter` (3–12 mm). The scan is noisy and may not be watertight — measure it any way you can and prefer round numbers where the scan is ambiguous. Keep the mesh imported in the part while you work.

What the AI judge checks

• The overall form matches the reference: the same kind of object, the same silhouette from the matching angle
• Proportions match: the relative sizes of the major dimensions agree with the reference within what the eye can judge
• Every major feature visible in the reference (holes, slots, bosses, tabs, lips) is present in the result
• Those features sit where the reference has them
• Nothing is present that the reference does not show — no decorative or unexplained geometry
• A clean block with flat faces and one round hole — the scan's noise is gone
• The hole is visible from both the top and bottom views

Measured checks

• one sub-part named block (gate)
• bounding box within 0.5 mm of the mesh (gate)
• volume within 5 % of the mesh (gate)
• symmetric difference under the measured floor
• the bore is 10 mm
• the bore goes all the way through
• the imported scan is still declared as an import
• asked the oracle at most once