Laser box printed hinges

Sonnet 5.5, effort high$0.1651s49s waiting on the model1 build

iso
front
back
top
bottom
left
right

100of 100

built: 100
geometry: 100
AI judge: 6 of 6

What the AI judge checked

Pass:An open box built from flat panels — a bottom and four walls — with a separate flat lid
- Opus 5.5: pass: Renders show a bottom panel and four walls forming an open box, plus a separate flat lid panel.
- GPT-6 Sol: pass: The renders show a bottom and four flat walls forming an open box, with a separate flat lid raised above it.
Pass:The corners are finger-jointed: the fingers of adjoining panels interlock rather than overlapping or leaving gaps
- Opus 5.5: pass: Corner edges show alternating finger/slot patterns that interlock flush with no visible overlaps or gaps.
- GPT-6 Sol: pass: Alternating fingers meet along the corners and bottom edges without visible gaps or overlapping panels.
Pass:Two hinges sit along the back edge, joining the lid to the back panel
- Opus 5.5: pass: Two knuckle hinges sit along the top back edge, with leaves on the back panel and the lid (visible in the back view).
- GPT-6 Sol: pass: Two hinge assemblies are visible along the rear edge between the lid and back panel.
Pass:The word TOOLS is engraved on the front panel and is legible
- Opus 5.5: pass: The front view clearly shows the word TOOLS engraved in readable letters.
- GPT-6 Sol: pass: TOOLS is clearly legible on the front panel.
Pass:The lid is attached through the hinges rather than floating free of the box
- Opus 5.5: pass: The lid is held open at the back edge by the hinge knuckles that connect it to the back panel.
- GPT-6 Sol: pass: The raised lid visibly connects to the back panel through both hinges.
Pass:No floating, detached or unexplained geometry
- Opus 5.5: pass: All geometry is accounted for: the panels, the hinges, and the hinge tab slots, with nothing floating or unexplained.
- GPT-6 Sol: pass: All visible geometry belongs to the box, lid, lettering, or hinge assemblies.

Measured

✓ at least five sheet panels: ok
✓ sheet thickness bound to a control: ok
✓ a clearance control and no kerf control: ok
✓ the clearance control is one the kit's README lists: ok
✓ at least two printed parts: ok
✓ verify.ok from declared expectations: ok
✓ the cut & print kit builds: ok
✓ the kit carries print files for the hinges: ok

Loading the transcript…

This is an older run. See the current results.

Run kimi31-sonnet-hard2026-11-05commit 58201d93spend $50.99 + $14.79 AI judgingOther runs: 2026-11-05T05-50-12-kimi31-vs-sonnet, 2026-10-16T18-49-10-hard-compact-2026-10-16, 2026-09-23T06-56-16-hard-baseline-2026-09-23, 2026-09-10T19-44-23-baseline-2026-09, 2026-09-04T20-02-10-stage2-hard-cases, 2026-09-04T19-48-31-screen-14-fixed