Drawer divider

Kimi K3.1 Pro$0.0632s32s waiting on the model1 build

100of 100

What the AI judge checked

Pass:A long thin flat plate
- Opus 5.5: pass: Renders show a long, thin rectangular plate roughly 5:1 length to height with very small thickness in top/side views.
- GPT-6 Sol: pass: The renders show one long, thin, flat rectangular plate.
Pass:Several narrow slots cut down from the top edge, all the same depth
- Opus 5.5: pass: Front view shows four narrow slots cut from the top edge, all ending at the same depth around half the height.
- GPT-6 Sol: pass: Four narrow slots descend from the top edge to the same depth.
Pass:The slots are evenly spaced with equal solid ends
- Opus 5.5: pass: In the front view slots sit at about 235, 420, 604, 788 px with plate edges at 51 and 973, giving equal ~184 px steps including the ends.
- GPT-6 Sol: pass: The slot centres appear evenly spaced, with equal distances to the two plate ends.
Pass:Nothing else was added to the plate
- Opus 5.5: pass: No extra features beyond the plate and slots are visible in any view.
- GPT-6 Sol: pass: No features other than the four slots are visible on the plate.

✓ watertight: true == true
✓ holes: 0 == 0
✓ one sub-part named divider: ok
✓ length is exposed as 100 to 400: ok
✓ slots is exposed as 2 to 8: ok
✓ default plate is 200 x 2 x 40: ok
✓ every slot is open and evenly spaced, the ends are solid: ok
✓ each slot is 2.2 mm wide, with plate either side of it: ok
✓ each slot is 20 mm deep, with plate below it: ok
✓ sweep length=100: watertight: true == true
✓ sweep length=100: holes: 0 == 0
✓ sweep length=100: swept build is not empty: ok
✓ sweep length=100: every slot is open and evenly spaced, the ends are solid: ok
✓ sweep length=100: length tracks the control: ok
✓ sweep length=400: watertight: true == true
✓ sweep length=400: holes: 0 == 0
✓ sweep length=400: swept build is not empty: ok
✓ sweep length=400: every slot is open and evenly spaced, the ends are solid: ok
✓ sweep length=400: length tracks the control: ok
✓ sweep slots=2: watertight: true == true
✓ sweep slots=2: holes: 0 == 0
✓ sweep slots=2: swept build is not empty: ok
✓ sweep slots=2: every slot is open and evenly spaced, the ends are solid: ok
✓ sweep slots=5: watertight: true == true
✓ sweep slots=5: holes: 0 == 0
✓ sweep slots=5: swept build is not empty: ok
✓ sweep slots=5: every slot is open and evenly spaced, the ends are solid: ok
✓ sweep slots=8: watertight: true == true
✓ sweep slots=8: holes: 0 == 0
✓ sweep slots=8: swept build is not empty: ok
✓ sweep slots=8: every slot is open and evenly spaced, the ends are solid: ok

Loading the transcript…