Drawer divider

Kimi K3 Fast$1.177m 22s7m 22s waiting on the model1 build

30of 100

A gate failed, so geometry scores zero for this attempt.

Measured

✓ watertight: true == true
✓ holes: 0 == 0
✓ one sub-part named divider: ok
✗ length is exposed as 100 to 400: predicate returned false
✓ slots is exposed as 2 to 8: ok
✗ default plate is 200 x 2 x 40: predicate returned false
✗ every slot is open and evenly spaced, the ends are solid: predicate returned false
✗ each slot is 2.2 mm wide, with plate either side of it: predicate returned false
✗ each slot is 20 mm deep, with plate below it: predicate returned false
✗ sweep: control "length" is not exposed: the part's defaults carry no "length"
✓ sweep slots=2: watertight: true == true
✓ sweep slots=2: holes: 0 == 0
✓ sweep slots=2: swept build is not empty: ok
✗ sweep slots=2: every slot is open and evenly spaced, the ends are solid: predicate returned false
✓ sweep slots=5: watertight: true == true
✓ sweep slots=5: holes: 0 == 0
✓ sweep slots=5: swept build is not empty: ok
✗ sweep slots=5: every slot is open and evenly spaced, the ends are solid: predicate returned false
✓ sweep slots=8: watertight: true == true
✓ sweep slots=8: holes: 0 == 0
✓ sweep slots=8: swept build is not empty: ok
✗ sweep slots=8: every slot is open and evenly spaced, the ends are solid: predicate returned false

Loading the transcript…

Run hard-baseline-2026-09-232026-09-23commit 6edf19e0spend $212.67 + $43.09 AI judging, 15 unpricedstopped early (interrupted)Other runs: 2026-09-10T19-44-23-baseline-2026-09, 2026-09-04T20-02-10-stage2-hard-cases, 2026-09-04T19-48-31-screen-14-fixed