Filleted tray

The request

Make a shallow parts tray, open at the top: 80mm long, 60mm wide, 15mm tall overall, with 3mm walls and a 3mm floor. Round the edges around the top rim with a 2mm fillet, and chamfer the bottom edge where the tray meets the build plate by 1.5mm. Model it as a single sub-part named `tray`.

What the AI judge checks

• The edges around the top rim are visibly rounded rather than sharp
• That rounding runs all the way around the rim at a consistent radius, not on some edges only
• A small bevel where the outside wall meets the bottom face, running continuously around it
• The bottom face is flat, so the tray would sit level on a table
• The walls, floor and cavity are clean and flat, with no ripples, steps or stray geometry

Measured checks

• watertight (gate)
• 80x60x15 outer envelope
• hollow tray, not a solid block
• has real wall material